Zhenzhou Zhize Trading Co.,Ltd
Contact US
Address: Room 702, Building 1#, Futian Caifu Square, Economic and Developpment Arear, Zhengzhou, Henan Province, China
TEL: +86-371-86629579
MOB : +8618530930416
whatsapp: +8618530930416
                
Home > Exhibition > Content
Clutch precautions
- Jul 24, 2017 -

1, the clutch must be cleaned before installation, remove the anti-rust grease and debris.

2, the clutch can be coaxial installation, can also be sub-axis installation, the axial must be fixed, the active part and the passive part are not allowed to have axial movement, sub-axis installation, the active part of the axis and the coaxial axis Degree should not be greater than 0.lmm.

3, wet electromagnetic clutch work, must be added between the friction plate lubricating oil, lubrication (1) sub-oil lubrication; (2) oil bath lubrication, the part of the oil immersed in the clutch about 5 times the volume; 3) Axial oil supply lubrication, in the high-speed and high-frequency operation should be used axle oil supply method.

4, jaw mounted electromagnetic clutch installation, must ensure that there is a certain gap between the end of the teeth, so that when the idle without grinding teeth, but not greater than the value of δ.

5, electromagnetic clutch and brake for the B-class insulation, the normal temperature rise of 40 ℃. Ultrasonic balance of the working temperature is not allowed to speed 100 ℃, otherwise the coil and the friction part of the easy to damage.

6, power and control lines, clutch power supply for the DC 24 V (except for special orders). It consists of three-phase or single-phase AC voltage by step-down and full-wave rectification (or bridge rectifier) to get, no voltage regulator and the power required to be large enough. Do not allow half-wave rectifier power supply.

7, the automotive transmission system on the clutch requirements


Previous: No Information

Next: Friction clutch